Preliminary Work; Heater Installation Location - Webasto Thermo Top Evo Installation Documentation

Opel Astra

Preliminary Work

Vehicle
• Open the fuel tank cap.
• Ventilate the fuel tank.
• Close the fuel tank cap again.
• Depressurise the cooling system.
• Disconnect the battery.
• Completely remove the air filter.
• Remove the windscreen wiper.
• Remove the coolant reservoir cap.
• Remove the coolant reservoir.
• Remove the windscreen wiper motor with linkage.
• Remove the upper engine cover (diesel only).
• Remove the insulation mat of the firewall on the right.
• Remove the right wheel.
• Loosen the right wheel-well inner panel.
• Remove the fuel-tank (petrol only).
• Remove the fuel-tank sending unit in accordance with the manufacturer's instructions (petrol only).
• Remove the footwell trim on the front passenger's side.
• Remove the glove compartment.
• Remove the driver's side storage compartment.
• Remove the lateral instrument panel trim of the centre console on the driver's and the front passenger's side.
• Remove the A-pillar trim on the front passenger's side.
Heater
• Remove years that do not apply from the type and duplicate label.
1
Ident. No.: 1319153A

Heater Installation Location

Image shows diesel vehicle.
1 Heater
1
Status: 02.01.2013
Installation
location
© Webasto Thermo & Comfort SE 5