20. Using five M4 8 pan-head screws, install the wireway access
cover. See Figure 18. Torque the screws to 1.7 ± 0.2 Nm
(15 ± 2 lb in).
Figure 18. Wireway Access Cover Installation
21. Verify that the six information labels are attached to the wireway as
shown in Figure 19.
Figure 19. Wireway Labels
Eaton BladeUPS Bar Installation Guide
Rear of Rack
S
164201723 Rev 2 www.eaton.com/powerquality
INSTALLATION
M4
8 Pan-Head Screws
(5 places)
Wireway Access Cover
Labels
23