Ack/Nak Timeout; Switch Between Master/Slave Mode - CipherLab Cipher Lab 1560 User Manual

2.3.3 ACK/NAK TIMEOUT

By default, the scanner sends data to the host without waiting for an ACK/NAK response
before sending more data. Specify a value, ranging from 1 to 99 in units of 0.1 second. If
no response within the specified period of time, the scanner will attempt to send the
same data two more times. If all three attempts fail without any notification, data loss
will occur.
1) Read the barcode above to specify the time interval for the scanner to send data and
wait for a response from the host.
2) Read the "Decimal
scanner to automatically shut down after idleness of 1 second.
3) Read the "Validate" barcode on the same page to complete this setting.
ACK/NAK Error Beep
Note: We suggest enabling the error beep so that you will be notified of such data loss
and have the scanner re-read data.

2.3.4 SWITCH BETWEEN MASTER/SLAVE MODE

After the scanner has established a connection as a SPP slave device, you may have it
read the "Activate BT SPP, Master Mode" setup barcode to switch to SPP Master Mode.
This will result in easy and reliable re-connection, just like connecting with 3656.
Value" barcode on page 227. For example, read "1" and "0" for the
Chapter 2
ACK/NAK Time-out
after ... (*0~99)
Enable Error Beep
*Disable Error Beep
Update
Selecting Output Interface
71