CipherLab Cipher Lab 1560 User Manual page 37

Note: Power-Saving won't take effect when one of the following conditions is met:
(1) the scanner has already established a BT HID/SPP connection,
(2) the scanner is in the configuration mode,
(3) the scan mode is set to Test, Continuous or Alternate Mode,
(4) 1560 is in Auto-Sense mode and seated in the 3656 stand, or
(5) the setting value of Power-Saving is greater than that of Auto Power Off.
1.1.2.2 AUTO POWER OFF
For the scanner to save power, further to setting up "Power-Saving" mode, you may also
need to enable "Auto Power Off", which deals with a time for the scanner to automatically
power off after power-on. Make the configuration that best suits your application while
noting the following points:
Auto Power Off: 1~254 minutes configurable. 0= Disable.
1. By default, the scanner automatically shuts down 10 minutes after power-on.
2. If Auto Power Off isn't desired, set the parameter to 0 to disable it.
3. When the scan mode is set to any of Continuous Mode, Test Mode, and Alternate
Mode, you need to enable "Auto Power Off Ignoring Scan Mode" in addition to
enabling "Auto Power Off". See the following section
Ignoring Scan Mode
Note: When the scanner is set to any scan mode other than Continuous Mode, Test Mode
and Alternate Mode, you can skip "Auto Power Off Ignoring Scan Mode".
1) Read the barcode above to enable the scanner to automatically turn off at a specified
time after power-on.
2) Assign the auto power off time by reading the
For example, read "1" and "5" for the scanner to automatically turn off after idleness
of 15 minutes.
3) Read the "Validate" barcode on the same page to complete this setting.
Chapter 1
to achieve auto power off.
Auto Power Off after
Understanding the Barcode Scanner
1.1.2.3 Auto Power Off
0~254 min. (*10)
"Decimal Value" barcode on page 227.
Update
25