Loading And Starting The Power Paper Stacker - IBM 6400 Setup Manual

Chapter 2
Power Paper Stacker Option
$
Bearing Bracket
5. Set the desired paper length (5-12 inch range), as follows:
Grasping the paddle shaft, push or pull toward the front or the rear of the
printer, setting the desired paper length by aligning indicator notch on the
bearing bracket with the paper length indicator.
6. Press Stacker Down.

Loading And Starting The Power Paper Stacker

1. Using the rear operator panel, press the PAPER ADVANCE key and
hand feed the paper until paper reaches the wire tent and there is an
excess of 3 to 5 pages. Be certain the paper passes through the paper
stacker throat smoothly.
2. Stack the 3-5 sheets of paper on top of the wire paper tent, making sure
the paper lies with the natural folds.
3. On the printer's main operator panel, the printer displays "OFFLINE." If a
message other than "OFFLINE" displays in the operator panel, refer to
Chapter 6, "Routine Service and Diagnostics" on page 225.
4. Press the START key on the operator panel or the ONLINE key on the
rear operator panel. "READY" displays on the LCD and the "ONLINE" on
the rear operator panel is lit. The stacker frame returns to its proper
position for printing.
5. Check to ensure paper is still centered between paper guides.
6. Close the rear cabinet door.
80
$
Paddle Shaft
Figure 58. Setting Paper Length
Paper Length Indicator