IBM 6400 Setup Manual page 237

Fault Message
011 SCS COMMAND
ERROR
012 STRUCTURED FIELD
ERROR
013 ACTIVATE LOST
014 INVALID ACTIVATE
015 COMMUNICATION
CHECK
CHECK CABLE
016 INVALID COMMAND
017 STACKER JAM
CHECK STACKER
018 STACKER FULL
CHECK STACKER
019 STACKER FAULT
CHECK STACKER
021 RECEIVE BUFFER
OVERRUN
VERIFY CONFIGURATION
022 UNIT ADDRESS NOT
RECEIVED
CHECK PRINTER
ADDRESS
Table 11: Fault Messages
Operator
Explanation
Correctable?
No Printer received
undefined control
character.
No Applications software
has violated structured
data field parameters.
No Printer detects twinax
protocol communication
errors.
No Printer detects twinax
protocol communication
errors.
Yes Line not active. (Twinax
interface)
No Printer detects twinax
protocol communication
errors.
Yes Paper is jammed in the
power stacker area.
Yes Power stacker is full of
paper.
Yes Stacker is not functioning
correctly
Yes Receive overrun. (Serial
interface)
Yes Unit address not
recognized by printer.
(Poll timeout, twinax
interface)
Fault Correction Procedure
Solution
Contact your system
administrator.
Contact your system
administrator.
The printer reports the
error.
The printer reports the
error.
Check cable connection.
The printer reports the
error; host action is
required.
Remove paper.
Remove paper.
Check for obstructions in
the stacker area. If fault
persists, contact your IBM
service representative.
Check printer serial port
configuration setup.
Ensure that baud rate
matches both host and
printer settings.
Ensure that printer address
matches host setting.
237