IBM 6400 Setup Manual page 275

The following entry should be placed in the VTAM MODE TABLE specified
above or another of your choice.
6400SCSL MODEENT LOGMODE=6400SCSL,
FMPROF=X'03',TSPROF=X'03',PRIPROT=X'B1',
SECPROT=X'90',COMPROT=X'3080',RUSIZES=X'8787,
PSERVIC=X'01000000E100000000000000',
PSNDPAC=X'02',SRCVPAC=X'02',SSNDPAC=X'00'
Step 2 - JES2 Definition (SYS1.PARMLIB)
RMT1
LUTYPE1,BUFSIZE=3840,LINE=1,NUMRD=0,NUMPR=1,NOCOMP,NOCM
PCT,
SETUPHDR,CONSOLE
R1.PR1
CLASS=A,NOSEP,PRWIDTH=132,NOFCBLOD,WS=(W,R,Q,PMD,LIM,F,T/
C,P),
CKTPAGE=30
DESTID NAME=LOC6400,DEST=R1
Step 3 - Define to CICS or another application program
An application program must provide the SCS commands to control the
printer. CICS, VPS, and other applications support SCS as well as numerous
application programs, both customer written and vendor supplied. Refer to the
vendor documentation for defining an SCS printer to the program for its use. If
there is no specific information on the 6400 you may use the IBM 4234 for
reference.
Step 4 - Printer Settings
It is recommended that the following printer settings be changed from factory
default settings:
•
Printer Control => Interface Selection => Coax
•
Coax Interface => Format Control => Enable
6400-LU1-SCS-Local SNA 3174 Control Unit
275