Setting Rear Paper Exit
Setting Rear Paper Exit
1. Press Stop to place the printer in NOT READY state.
NOTE: If there is paper in the printer, unload the paper, then continue with
step 2 of this procedure.
Thumbscrew
Figure 25. Loosening the Hinge Thumbscrews
2. Open the printer cover.
3. Loosen the two hinge adjustment thumbscrews.
4. Slide the cover forward until it stops.
Figure 26. Selecting Between Top and Rear Exit Options
5. Tighten the two hinge adjustment thumbscrews.
6. Place the paper guide in its lower position.
57