IBM 6400 Setup Manual page 178

Chapter 4
IGP Feature (PGL)
Skip Command Prefix
This parameter determines if a data string before an IGP command will be
ignored.
•
Disable. The printer will print any data before an IGP command.
•
Enable. (the default.) The printer ignores all text before an IGP
command.
Power On IGP
You can set the IGP feature so that it is enabled or disabled when the printer
is powered on.
•
Disable. The IGP is disabled when the printer is powered on. (The IGP
feature is initialized to the Quiet mode.)
•
Enable. (the default.) The IGP is enabled when the printer is powered on.
(The IGP feature is initialized in the Normal mode.)
Extended Execute Copy
•
Disable. (the default.) Dynamic data, overlay data, etc. are not allowed if
the optional Form Count parameter (number of forms to print) is specified
as part of the Execute command. (This setting is IGP-100/200/400
compatible.)
•
Enable. Dynamic data, overlay data, etc. are allowed within a form in
which the Form Count parameter is specified in the Execute command. In
this case, the exact same form (with identical dynamic data, etc.) is
printed for whatever the Form Count is. However, incremental data is not
incremented since the page that is printing is exactly the same. Also,
each form is printed on a separate page.
UPC Descenders
This parameter determines if a gap is left for human readable data in UPC/
EAN bar codes, even if there is no human readable data. There will be no
change if there is human readable data.
•
Disable. The IGP does not leave a gap if there is no human readable
data.
•
Enable. (the default.) The IGP leaves a gap, even if there is no human
readable data.
Compressed CPI
This parameter allows you to choose a compressed character for CPI instead
of the normal height character.
•
Disable. (the default.) The IGP does not use the compressed CPI font.
•
Enable. The IGP uses the compressed CPI font.
178