Chapter
2
Connect The Interface And Power Cables (Pedestal Models)
Connect The Interface And Power Cables (Pedestal Models)
<1>
<4>
<5>
1. Verify that the voltage source at the printer site conforms to the
requirements specified on page 34.
2. Open the box containing the power cord, printer ribbon, and operator
panel overlay label. Refer to "Cables" on page 256 for recommended
cables.
64
DANGER
Before powering on the printer, ensure the printer is plugged into
an appropriate power source. Refer to page 33 for information on
the proper source.
Do not connect or disconnect any communication port, teleport,
attachment connector, or power cord during an electrical storm.
Power off the printer and disconnect the power cord before
connecting or disconnecting communication port, teleport, or
attachment cable connector.