IBM 6400 Setup Manual page 246

Chapter 6
Fault Messages
Fault Message
OPERATOR MENU
<first menu item>
OPERATOR MENU
LOCKED
OPERATOR MENU
UNLOCKED
PA1 SELECTED
PA2 SELECTED
P05 DIAGNOSTIC TEST
PASSED
P17 SECURITY VIOLATION
PLEASE WAIT...
RESET IN PROGRESS
READY
RIBBON INK OUT
CHANGE RIBBON
SERVICE MENU
<first service test>
TESTING HARDWARE
PLEASE WAIT
TOP OF FORM SET
246
Table 11: Fault Messages
Operator
Explanation
Correctable?
N/A Non–error status
message.
N/A Non–error status
message.
N/A Non–error status
message.
N/A Attach status message.
N/A Attach status message.
N/A Non–error status
message.
No Security code of PAL on
controller board does not
match code of firmware
on the controller board.
N/A Printer reset in progress.
N/A Printer state message:
printer is online and in
communication with
host.
Yes RibbonMinder has
determined that the
ribbon is out of ink.
N/A Non–error status
message.
N/A Status message when
printer runs self–tests
and initialization
routines.
N/A Non–error status
message.
Solution
No action necessary.
No action necessary.
No action necessary.
No action necessary.
No action necessary.
No action necessary.
Contact your IBM service
representative.
No action necessary.
No action necessary.
Replace the ribbon and
verify ribbon life is reset to
100%.
No action necessary.
No action necessary.
No action necessary.