Siemens HiPath 2000 Administration Manual page 89

SNMP Server Address
• If an SNMP server exists in the network, enter the
this server here.
• Default address
Page 63
SNMP Trap Port
• Define the Port here through which the
should be transmitted.
Page 63
SRSR Automatic Switch Back
• Activate this checkbox for executing an automatic switch between
standby mode (emergency mode) and home mode (standard mode) of
the communication platform.
Page 67
SRSR Enabled
• Activate this checkbox if two communication platforms are used (Main
PBX and Standby
• The Gateway Address and
PBX must be entered
Page 67
SRSR Switch To Home Expiry Timeout
• Required waiting time for changing from standby mode (emergency
mode) to home mode (standard mode). During this time a switch over
is not possible.
• Valid values: 1 ... 255.
• Default value
Page 67
SRSR Switch To Home Retry Count
• Maximum number of negative attempts for switching over from home
mode (standard mode) to standby mode (emergency mode).
• Valid values: 1 ... 255.
• Default value
Page 67
SRSR Switch To Standby Expiry Timeout
• Required waiting time for changing from home mode (standard mode)
to standby mode (emergency mode). During this time a switch over is
not possible.
• Valid values: 1 ... 255.
• Default value
Page 67
Page 109.
PBX).
Subscriber Number of the Standby
Page 65.
Page 109.
Page 109.
Page 109.
Alphabetical Reference
IP Address of
SNMP error messages
89