Administration Scenarios
Checking Handset Functionalities
•
•
•
Startup Not Successful
Check whether one or more of the mentioned questions are valid for your
configuration:
Is the optiPoint 410/420 being operated in a
•
Is the optiPoint 410/420 being operated behind a
•
Checking the LAN Connection
•
•
Establishing the Software Version
You can determine the version of the software that is running the
optiPoint 410/420, for example during a pending software update.
104
Check whether the plugs at the two ends of the handset cable are
inserted correctly (handset engaged)
Carry out an Audio Loop Test.
– More information on „Audio Loop Test"
–
Page 27
Ensure that the handset microphone is not switched off.
– For more information, see the operating instructions for the
optiPoint 410/420.
Enter the VLAN ID manually, or, if a
the „VLAN Method"
transferred from the DHCP server is used.
– More information on „Default VLAN ID"
Page 23
Page 63
Enter the
IP Address of the gateway in
Page 23
Page 62
Check whether the plugs at the two ends of the LAN cable are
correctly inserted (handset engaged)
Check the connection with the help of the PING test.
– More information on „PING Test"
Page 34
Page 59
Page 51
Page 13.
DHCP server is being used, set
Page 93 to "DHCP", so that the VLAN ID
Page 13.
Page 85.
Page 70.
VLAN?
Page 73.
Gateway?
Default Route.