Siemens HiPath 2000 Administration Manual page 73

Debug Mode
• Only on optiPoint 410/420 standard/advance in conjunction with a
display module or application module.
• This setting is required for application developers.
• Please do not change this setting.
Page 57
Debug Program on Server
• Only on optiPoint 410/420 standard/advance in conjunction with a
display module or application module.
• This setting is required for application developers.
• Please do not change this setting.
Page 57
Default Route
• Enter the IP Address that was assigned to your
DHCP server assigns this value dynamically.
• If the value was assigned dynamically, it can only be read.
• A restart is necessary after the change.
• Default value
• IP editor on optiPoint 410/420
Page 23
Default SNTP IP
• This entry is only required if you selected "SNTP" in the
field.
• Enter the IP Address of the
Page 67
Default VLAN ID
• Can only be defined if
• Enter a value from 0 to 4095 here. This value describes the association
with a certain VLAN if a
Page 23
Delete Program
• Only on optiPoint 410/420 standard/advance in conjunction with a
display module or application module.
• Delete the selected program.
Page 57
Page 109.
Page 106.
Page 18 Page 62
SNTP server.
Layer 2 support is activated (
VLAN is used.
Page 18 Page 62
Alphabetical Reference
PBX if no
Time Source
QoS L2/L3).
73