Table of Contents
Advertisement
System Installation
Installing Remote Keypads and LECs
The following types of devices may be connected to the control panel:
NETLED
NETSTAR
NETARM
TS700.LEC
Any combination of devices can be used on the same system, providing the total number does
not exceed four.
1.
Always ensure that all power (mains and battery) is removed before making any connections
to the remote keypad.
2.
Separate the cover and base by using a screwdriver to push 2 of the clips (top or bottom)
inward from the base indents, then lift the cover assembly, noting that the PCB is fixed to the
under side of the cover.
3.
Hold the base in position (keyhole to the top) and mark the three securing holes, drill and plug
the wall as required. Pass all the cables into the base via the cable entry points as
appropriate and secure the base to the wall.
4.
Connect "Remote Network" and detection circuit cables to the appropriate terminals, see
Figure 4.
5.
Set the I/D selector jumper link to the required position:
I/D Selector
1
2
3
4
ENG / NULL
No two remote keypads or LECs should have the same I/D.
If the I/D is set to "ENG" the remote keypad will function as an Engineer's keypad
allowing it to be plugged onto the control panel so that system programming and
testing may be carried out (see Engineer's Keypad).
6.
For details on all remote keypad option links, please refer to the instructions supplied with the
remote keypad.
7.
Finally clip the remote keypad cover onto the base being careful not to trap any cables or to
obstruct the tamper switch.
Engineer's Keypad
Normally all system programming will be carried out from one of the installed remote keypads.
However sometimes it may be more convenient to program the system at the control panel, this
can be achieved by using an Engineers Keypad. This is temporarily plugged on to the control
panel (JP2). To convert a standard remote keypad to an "Engineers Keypad" an interface lead
can be obtained from your supplier (P/No. NETEKI).
8
4 x 7 Segment LED display.
-
8 Character Starburst LCD display.
-
Remote Arming station (Power LED & programmable "Function" LED).
-
2 zone local expansion card.
-
Circuit A
09
11
13
15
N/A
TS700 Installation Manual
Circuit B
10
12
14
16
N/A
Panel Output
5
6
7
8
N/A
Hide quick links:
Advertisement
Table of Contents
