Specifications; System Configuration - Menvier Security TS700 Installation & Programming Instructions

Overview
A printer type CPA6.P (obsolete) or a standard RS232 serial printer via a Menvier Printer
Adaptor (MPA/DCI) can be connected to provide a printout of the 200 log events and system
parameters.
An output module type CPA6.OM can be connected to provide an output to a set of
LEDs/relays to indicate circuit activation. Each module will provide up to eight circuit
indications and two modules can be "daisy chained" to provide up to sixteen outputs.

Specifications

Input Voltage:
Control Panel:
Power Supply Rating:
NETSTAR Remote Keypad:
NETLED Remote Keypad:
NETARM Arming Keypad:
Battery:
Zones with tamper loops:
Panel dimensions:
Panel weight (w/o battery):
Remote Keypad dimensions:
Remote Keypad weight:
Environment:

System Configuration

Printer
Speaker
Aux 12V
Printer
Bell output
Strobe output
Digi outputs 1- 8
Outputs 1- 4
Figure 1. TS700 System Configuration
4
240V +/-10% 50Hz
110mA (normal) 190mA (alarm with extension speaker)
1.5 Amp
50mA (normal) 60mA (alarm)
60mA (normal) 70mA (alarm)
30mA (normal) 40mA (alarm)
12V 7Ah Sealed Lead Acid type
10 - 16
383w x 312h x 95d mm
4.4kg
150w x 100h x 30d mm
280g
0 - 55 °C
Remote
Network
TS700
8 Zones
(DP / EOL)
Number of Zones =10 to 16
1 Output 1 Output
Remote Remote
Keypad Keypad
or LEC or LEC
2 Zones 2 Zones
(DP / EOL) (DP / EOL)
TS700 Installation Manual
1 Output 1 Output
Remote Remote
Keypad Keypad
or LEC or LEC
2 Zones 2 Zones
(DP / EOL) (DP / EOL)