Programmable Outputs - Menvier Security TS700 Installation & Programming Instructions

TS700 Installation Manual

Programmable Outputs

The TS700 has many programmable outputs which can be used to drive relays, LED's etc. Each
output can be programmed for a different function, see "Programmable Output Types" on page
17.
Control Panel Outputs
The control panel has four high current programmable outputs:
[-1]
[-2]
[+3]
[+4]
Remote keypads & LEC Outputs
Each remote keypad and TS700 LEC has one programmable output:
[O/P]
+ve O/P
(Programmed as Alarm / Bell / etc)
Aux 0V
+ve O/P
(Programmed as Detector Reset)
Aux 0V
+ve O/P
Aux 0V
+ve O/P
Aux 0V
+ve Outputs
Figure 10. Programmable Outputs Wiring Examples
Set of voltage free changeover contacts rated at 1 Amp.
-
Switched -ve output rated at 500mA.
-
Switched +ve output rated at 500mA.
-
Switched +ve output rated at 500mA.
-
Switched -ve output rated at 100mA.
-
Relay available from
Diode (IN418)
RS components
P/No. 346-946.
Relay Capable of switching
mains voltages
+ 12 V 0V
Smoke
Detector
1K0 Ohm Resistor
LED (Light Emiting Diode)
12V Buzzer
RS Part No. 245-051
Aux 12 V
-ve O/P
(Programmed as Alarm / Bell / etc)
Aux 12V
-Ve O/P
(Programmed as Detector Reset)
Aux 12V
-Ve O/P
Aux 12V
-Ve O/P
-ve Outputs
System Installation
Relay available from
Diode (IN418)
RS components
P/No. 346-946.
Relay Capable of switching
mains voltages
+ 12 V 0V
Smoke
Detector
1K0 Ohm Resistor
LED (Light Emiting Diode)
12V Buzzer
RS Part No. 245-051
13