Menvier Security TS700 Installation & Programming Instructions page 17

TS700 Installation Manual
No Type
00 Bell On
01 Strobe
02 SW12
03 Detector Reset
04 Walk Test
05 Alarm
06 PA
07 Fire
08 Set
09 Code Accepted Active for 10 seconds when any valid passcode is entered.
10 24 Hour
11 Second Alarm
12 Courtesy Light
13 Engr on Site
14 Ccts Omitted
15 Auxiliary
16 Sndr Control
17 Area Set A
18 Area Set B
19 Area Set C
20 Tamper
21 Line Fault
22 Mains Off
23 Exit/Entry
24 Test Fail
25 First Knock
26 DC Failed
27 DC Successful
28 DC Active
29 Second Entry
30 Entry
31 Exit
32 Part Set C fail
33 Part Set B fail
34 Part Set A fail
35 Part Set
36 Area C Alarm
37 Area B Alarm
38 Area A Alarm
39 Duress Alarm
40- 55 Circuit mimic
Active when the external Bell trigger is activated.
Active when the Strobe trigger is activated.
Used to latch devices in an alarm. Active when the system is set.
Used to power devices which require power to be removed to reset them.
Active when a Walk Test is in progress.
Active when intruder alarm is present.
Active when a PA alarm is present.
Active when a Fire alarm is present.
Active when the system is Set.
Active when a 24 hour circuit is in alarm.
Active when a second circuit causes an alarm, use for ALARM CONFIRMATION.
Active when any keypad is in use.
Active when the engineer's passcode is entered until a User passcode is entered.
Active when circuits are omitted.
Active when an Auxiliary circuit is in alarm.
Can be used as the 0V connection to an extension loudspeaker so that the
sounder is muted during keypad entries. Only suitable for panel outputs 1 & 2.
Active when area A is Set.
Active when area B is Set.
Active when area C is Set.
Active when a Aux, or circuit tamper is triggered.
Active when a digicom telephone line fault occurs.
Active when mains power is removed.
Active during exit and entry.
Active when a circuit on Test is activated.
Active when a double knock is activated for the first time.
Active if the digicom fails to communicate.(plug-on)
Active when the digicom sends a message and it is acknowledged. (plug_on)
Active while the digicom is triggered.(plug-on)
Active when the second entry timer is started.
Active when the system is set or part set and the entry route is in use.
Active when the system exit procedure is started.
Active when Part Set area C fails to set.
Active when Part Set area B fails to set.
Active when Part Set area A fails to set.
Active when ever the system is Part Set.
Active when Area C Alarms.
Active when Area B Alarms.
Active when Area A Alarms.
Active when a duress code is entered at a keypad.
Will mimic (active when circuit is active) circuits 1 to 16 respectively .
Table 2. Programmable Output Functions
Function
Programming
17