Fastening The Cooktop - Elba EH321 Instructions For Use Manual

Clearance
Space for
connections
A
Fig. 6.4
C
Fig. 6.5
20
Fig. 6.3
Cupboard
door
A
A
D
B
A
WITH CUPBOARD DOORS
(fig. 6.3)
The fixture has to be made according to
specific requirements in order to prevent
the gas burners from going out, even
when the flame is turned down to mini-
mum, due to pressure changes while
opening or closing the cupboard doors.
It is recommended that a 30 mm clear-
ance be left between the cooker top and
the fixture surface beneath it.

FASTENING THE COOKTOP

(fig. 6.4)
Each cooktop is supplied with a set of
tabs and screws to fasten it on units with
a working surface from 2 to 4 cm deep.
The kit includes 4 tabs "A" and 4 self-
threading screws "B".
A
Cut the unit.
Stretch gasket "D" over the edge of
the hole made, being careful to over-
lay the junction edges
Turn the cooktop over and put tabs "A"
(fig. 6.4) into the mountings, only tight-
en screws "B" a few turns.
Make sure that the tabs are mounted
correctly as shown in the figure 6.4.
Turn the tabs so that the cooktop can
be put into the hole.
Put the cooktop into the hole cut into
the unit and position it correctly.
Put tabs "A"; into place, tooth "C" of
the tabs should go into the hole.
Tighten screws "B" until the cooktop is
completely secured.
Using a sharp tool cut off the part of
gasket "D" which protrudes from the
cooktop.