Table of Contents
Advertisement
FASTENING THE COOKTOP
Each cooktop is provided with an installation kit including brackets and screws for fastening
the cooktop to benches from 30 to 50 mm thick.
The kit includes four metal clips "A" and four self-threading screws "B" (fig. 1.4a, 1.4b).
•
Cut the unit according to the dimensions in fig. 1.1.
•
Turn the hob upside down and rest the glass side on a soft surface.
•
Spread the seal "C" around the edge of the hob.
•
Put tabs "A" into the mountings by using the screws "B" (only tighten screws a few
turns).
Make sure that the metal clips are mounted correctly as shown in the figure 1.4b.
•
Put the cooktop into the cutout and position it correctly.
•
Put tabs "A" into place. Tighten screws "B" until the cooktop is completely secured.
•
If necessary, using a sharp cutter or trimmer knife, trim the excess sealing material
around the edge of the cooktop. Take care not to damage the workbench.
•
In case to install the hob flush with the work surface, fill any gaps between the glass
and along the perimeter of the work surface with insulating silicone, and wipe away
any excess.
IMPORTANT:
Spread
sealing material "C" around
the edge of the hob (edge of
the glass).
The sealing material "C"
must be installed correctly
to guarantee a perfect seal
between
the
and
the
unit.
installation
may
irreparable damage to the
appliance.
the
appliance
Incorrect
cause
C
Adhesive side
Adhesive side
Fig. 1.4b
C
B
A
Fig. 1.4a
11
11
Advertisement
Table of Contents
