Fig. 8.1
Fig. 8.2
230 V
L
N
(L )
1
2
PE
Fig. 8.3
30
A
F
230 V
L
N
Fig. 8.4
REPAIRS
REPLACING THE POWER SUPPLY
CABLE (for 2 electrical plates and
vitroceramic models)
Turn the cooktop over and unhook the
terminal board cover by inserting a
screwdriver into the two hooks "A" (fig.
8.1).
Open the cable gland by unscrewing
screw "F" (fig. 8.2), unscrew the terminal
screws and remove the cable.
The new supply cable, of suitable type
and section, is connected to the terminal
board following the diagram fig. 8.3.
REPLACING THE POWER SUPPLY
CABLE (for gas models)
- The supply cable must be replaced with
a cable of the same type.
- The electrical cable must be connected
to the terminal board following the dia-
grams of fig. 8.4.
FEEDER CABLE SECTION
GAS COOKING HOB
type "H05V2V2-F" or "H05RR-F"
resistance to temperatures of 90°C
230 V~
3 x 0,75 mm
ELECTRIC HOTPLATES COOKING
HOB
The external diameter of the supply
cable must not be more than 9 mm.
tipo "H05RR-F"
230 V~
3 x 1,50 mm
VITROCERAMIC COOKING HOB
The external diameter of the supply
cable must not be more than 9 mm.
type "H05RR-F"
230 V~
3 x 1,50 mm
2
2
2