Table of Contents
Advertisement
2
GAS SECTION
GAS INSTALLATION REQUIREMENTS
Important !
•
Before installation, make sure that the local distribution conditions (gas type and
pressure) and the adjustment of this appliance are compatible. The appliance
adjustment conditions are given on the plate or the label.
•
This appliance must be installed and serviced only by a suitably qualified,
registered installer with technical knowledge of both gas installation and
electricity. The installation or service must comply with the current editions of
the applicable standards, regulations, and codes of practice governing gas and
electrical installations.
•
Failure to install the appliance correctly could invalidate any manufacturer's
warranty.
This appliance is supplied for use on Natural gas, LPG or Town Gas (check the gas
regulation label attached on the appliance).
•
Appliances supplied for use on Natural gas: they are adjusted for this gas only and
cannot be used on any other gas (LPG or Town gas) without modification.
The appliances are manufactured for conversion to LPG and Town gas.
•
Appliances supplied for use on LPG: they are adjusted for this gas only and cannot be
used on any other gas (Natural or Town gas) without modification.
The appliances are manufactured for conversion to Natural and Town gas.
•
Appliances supplied for use on Town gas: they are adjusted for this gas only and
cannot be used on any other gas (Natural gas or LPG) without modification.
The appliances are manufactured for conversion to Natural gas and LPG.
If the Natural gas/LPG/Town gas conversion kit is not supplied with the appliance this kit
can be purchased by contacting the After-Sales Service.
CONNECTING THE COOKTOP TO THE GAS SUPPLY
•
The gas connection must be carried out by an authorised person according to
the relevant local standards.
•
Ensure that the room in which the cooktop is to be installed is adequately
ventilated, in compliance with applicable regulations.
•
Note: Connection to the gas supply may be made using either a rubber hose
(where permitted) or by using a flexible hose or rigid pipe.
•
The rear of the chassis is recessed to provide a channel for the appliance inlet pipe.
•
The gas connection fitting (brass elbow) can be turned in the direction required
(but never in a vertical or horizontal position) after loosening the elbow and
floating nut connection. Never attempt to turn the elbow without having first
loosened the floating nut.
•
The supplied sealing washers guarantee a good seal for the gas connection. We
recommend that you replace the sealing washers on the slightest sign of wear,
deformation or imperfection.
•
After connecting to the gas mains, check that the couplings are correctly sealed,
using soapy solution, but never a naked flame.
10
Advertisement
Table of Contents
