Elba EH321 Instructions For Use Manual page 22

ELECTRICAL PLATES AND VITROCERAMIC COOKING HOBS
Fig. 6.8a
TECHNICAL INFORMATION
FOR THE INSTALLER
Before installing the cooktop, remove
the protective film.
These cooking hobs are designed to be
embedded into kitchen fixtures measur-
ing 600 mm in depth and from 20 to 40
mm thick, for 2 electrical plates hob, and
from 30 to 40 mm thick for vitroceramic
hob.
In order to install the cooker top into the
kitchen fixture,
dimensions shown in figs. 6.8a and 6.8b
has to be made, keeping in consideration
the following:
– within the fixture, between the bottom
side of the cooker top and the upper
surface of any other appliance or
internal shelf there must be a
clearance of at least 30 mm;
– the cooker top must be kept no less
than 50 mm away from any side wall;
– the cooker top must be kept at a
distance of no less than 50 mm from
the rear wall.
– there must be a distance of at least
650 mm between the hob and any wall
cupboard or extractor hood positioned
immediately above (see fig. 6.9).
22
a hole with the
Fig. 6.8b
– the coatings of the walls of the unit or
appliances near the cooktop must be
heat resistant ("Y" protection against
heating in compliance with standards
EN 60335-2-6).
Do not instal the appliance near
inflammable materials (eg. curtains).
Fig. 6.9