FASTENING THE COOKTOP
Each cooktop is supplied with a set of tabs and screws to fasten it on units with a working
surface from 3 to 5 cm deep.
The kit includes 4 tabs "A" and 4 self-threading screws "B" (figs. 4.4, 4.4a, 4.4b).
•
Cut the unit.
•
Spread the sealing material "C" out along the fixture hole, making sure that the jun-
ctions overlap at the corners.
•
Turn the hob upside down and rest the glass side on a cloth.
•
Remove the no.4 screws "D" already fitted on the product; then put tabs "A" into the
mountings by using the screws "B" (only tighten screws a few turns).
Make sure that the tabs are mounted correctly as shown in the figure 4.4a or 4.4b
(depending on the thickness of the cooktop surface).
•
Put the cooktop into the hole cut into the unit and position it correctly.
•
Put tabs "A" into place. Tighten screws "B" until the cooktop is completely secured.
•
Using a sharp tool cut off the part of gasket "C" which protrudes from the cooktop. Take
care not to damage the workbench.
D
Fig. 4.4
20
D
D
Cooktop surface
30 mm thick
C
B
A
Fig. 4.4a
Cooktop surface
40 to 50 mm thick
C
D
B
A
Fig. 4.4b