Initial Setup Of The Factory-Installed Microsoft Windows Server 2003 R2 Sp2 Operating System; Hardware And Software Prerequisites - Sun Microsystems Sun Blade X6250 Installation Manual

For more information, see the man pages for pmconfig(1M) and power.conf(4).
Initial Setup of the Factory-Installed Microsoft
Windows Server 2003 R2 SP2 Operating System
This section describes how to complete the initial setup of the factory-installed
Microsoft Windows Server 2003 R2 operating system.
This section includes the following topics:
"Hardware and Software Prerequisites" on page 29
■
"Establishing Connection to the Server Module" on page 30
■
"Providing Customer Information for Windows Setup" on page 30
■
"Obtaining Updates Using SunLink" on page 31
■
For additional information, see the Sun x64 Servers Windows Server 2003 R2 Operating
System Preinstall Release Notes and the Sun x64 Servers Windows Server 2003 R2
Recovery Installation Guide.

Hardware and Software Prerequisites

Before proceeding, complete the physical installation of your system, including
cabling. For installation procedures, see
You might also want to configure the disk drive holding the Windows operating
system as part of a RAID array. As shipped, this drive is not configured for RAID. To
make the disk part of a RAID array while preserving the data on the drive, add the
drive to a mirrored RAID set (also known as hardware RAID Level 1).
When a Sun Blade RAID 5 Expansion Module is installed, SAS drives can be
installed in disk slots 0 through 3. These disks can be configured as RAID 0, 1, 5, or
10.
For more information, see the Sun Intel Adaptec RAID User's Guide.
Note – On servers equipped with a Sun Blade RAID 5 Expansion Module, you must
use the BIOS configuration utility described in the the Sun Intel Adaptec RAID User's
Guide. to initialize your hard drives before you can install an operating system.
"Inserting the Server Module" on page
Chapter 2 Installing and Configuring the Server Module
13.
29