Connecting To The Server Using A System Running Microsoft Windows - Sun Microsystems Netra X1 User Manual

For example, for a Netra X1 server connected to port 10000 on a terminal server
whose IP address is 192.20.30.10, you would type:
# telnet 192.20.30.10 10000
Connecting to the Server Using a System
Running Microsoft Windows
If you want to configure and operate a Netra X1 server from a PC or laptop running
Microsoft Windows, you can do so using the Windows Hyperterminal.
Note – The following procedure relates to Windows 98: other variants of Microsoft
Windows may differ slightly.
Note – If you use a Palm Pilot or similar device, make sure that Hot Sync Manager
is closed. If it is not closed, you will not be able to communicate with the server from
your PC or laptop.
1. Connect the RJ-45 patch cable to the port labelled "A LOM" on the rear of the
server.
2. Connect the other end of the patch cable to the DB-9 adapter.
3. Connect the DB-9 serial adapter to the COM1 serial port on your PC or laptop.
4. Open a Windows Hyperterminal:
a. Choose Start > Programs > Accessories > Communications > Hyperterminal
b. Run Hyperttrm.exe
5. In the Set Up New Session window:
a. Name the session.
b. Choose an icon.
c. Click OK.
6. In the Connect To window:
a. Click Edit.
Chapter 3 Communicating With the Server 23