How To Install With A Child Harness - Britax Encore 10 Instructions For Installation And Use Manual

HOW TO INSTALL WITH A CHILD HARNESS

USING WITH A CHILD HARNESS (PURCHASED SEPARATELY)
This booster seat is only suitable for use with Safe-n-Sound™Protecta PLUS™Harness
Series 220/2010 or Babylove EzyGo Harness™ Series BL220/2010. Refer to the instruction
book supplied with the Child Harness for full details of using and installing the Child
Harness. When installing the Child Harness into the vehicle and booster seat, connect the
upper anchorage strap to the VERSATETHER™ Catch on the Booster Seat's upper tether
strap (as shown below).
If required, use the extension strap supplied with the child harness for all other instances to
attach the harness to anchor points in the luggage area such as the vehicle floor or ceiling.
Not suitable for most other styles of child safety harnesses.
INSTALLING SAFE-N-SOUND PROTECTA PLUS™CHILD
HARNESS INTO VEHICLE WITHOUT EXTENSION STRAP
Hook the Child Harness attachment
clip (1) onto VERSATETHER™
Catch (2). Then hook attachment
clip (3) onto anchor fitting. Ensure
that none of the straps are twisted
and not passing over any sharp
edges.
1. Attachment Clip from Child Harness.
2. VERSATETHER™ Catch.
3. Booster seat Attachment Clip.
4. Anchor Fitting in the car.
NOTE: Do not use the VERSATETHER™catch on the Child Harness Clip (1).
VERSATETHER™catch (2) is only for use with a Child Harness.
20
Instructions for Installation & Use - Series No. 4900/A/2010
Child Harness Attachment Clip attaches to the
VERSATETHER™ Catch
1
1
2
3
4