Table of Contents
Advertisement
HOW TO INSTALL WITH A CHILD HARNESS
METHOD 1. USING LAP-SASH SEATBELT WITH THE CHILD
HARNESS
(Using Gated Slide provided with Child Harness.)
Refer to the Child Harness instructions to fit
Gated Slide and adjusting the car seatbelt.
Fit the Harness as detailed on page 18. Fit
Gated Slide to both lap and sash belt as
shown on pages 24 & 25. Ensure the Gated
Slide is positioned into the lap recess area
and close to the child, but not touching
the child. Thread the converted lap-sash
seatbelt through the harness strap loops as
shown left. Ensure there are no twists in the
harness, cross strap and seatbelt.
Where provided, fit the SLIDEGUARD™clip
to the lap part of the seatbelt with
the logo facing forward. The Lap Belt
SLIDEGUARD™clip should be used to
reduce the risk of your child submarining
(sliding forward on the base of seat).
IMPORTANT :
The Gated Slide must be removed
from the seatbelt if the booster seat
and Child Harness are no longer used
in the car to allow other users to use
the seatbelt as a lap-sash seatbelt.
NOTE: Seatbelt extenders should not be used if the
seatbelt is not long enough to fit around the child.
If a seatbelt extender is used then the seatbelt
buckle must not be in contact with the child.
Instructions for Installation & Use - Series No. 4900/A/2010
Converted
lap-sash
seatbelt.
Position the
Gated Slide
next to the
child but not
touching the
child.
25
Advertisement
Table of Contents
