Using With Child Harness - Britax Maxi Rider Instructions For Installation & Use

USING WITH CHILD HARNESS

USING LAP SASH BELT & PROTECTA™ CHILD SAFETY
HARNESS (If supplied)
Store in-built harness as detailed on pages 17-18.
Store Sash Guide in recess under cover.
Refer to Protecta™ Child Safety Harness (Series 120) instructions for full details of
using and installing the Protecta™ Child Safety Harness. When installing the harness
into the vehicle, connect the upper anchorage strap to the Versa-Tether™ Catch on
the Maxi Rider™ upper tether strap (as shown below).
Use the extension strap supplied for all other instances to attach the harness to anchor
points in the luggage area such as the vehicle floor or ceiling.
Not suitable for other styles of child safety harnesses.
INSTALLING
VEHICLE
Hook attachment clip of Harness (1) onto Versa-Tether™ Catch (2). Then hook attachment clip
(3) onto anchor fitting. Ensure that none of the straps are twisted or catching on sharp edges.
Attachment Clip from Harness.
1.
Versa-Tether™ Catch.
2.
Attachment Clip & Cover.
3.
4. Anchor Fitting.
Anchor Bolt.
5.
INSTALLING PROTECTA™ CHILD SAFETY HARNESS WITH
EXTENSION STRAP INTO VEHICLE
Hook the Protecta™ Child Safety Harness clip first onto the extension strap catch,
then hook the extension strap hook onto the Versa-Tether™ Catch on the Maxi
Rider™ upper anchorage strap as shown below. Ensure that none of the straps are
twisted or catching on sharp edges. Tighten Maxi Rider™ Upper anchorage strap
(refer to page 12) then remove excess slack from the extension strap by pulling the
adjuster strap as illustrated below.
Protecta™ Child Safety Harness
Extension Strap (Supplied with Protecta™ Child Safety Harness)
22
Forward Facing (14 kg up to 26 kg)
PROTECTA™ CHILD SAFETY
1
2
Pull to remove
slack
HARNESS INTO
3
5
4
Upper Anchorage
Versa-Tether ™
Catch
(Not Supplied)
Strap
Anchor
Fitting