Table of Contents
Advertisement
HOW TO INSTALL CHILD HARNESS
INSTALLATION METHOD
If the seating position has a lap only seat belt then no other vehicle seatbelt preparation is
required.
If the seating position has a lap-sash seatbelt then it MUST be converted into a lap belt by fitting a
Gated 3 bar slide, see page 32.
The top tether must be correctly fitted for all installations.
CAUTION:
ALWAYS FOLLOW THE CHILD HARNESS INSTRUCTIONS.
IMPORTANT :
The SecureGuard™ Device MUST ALWAYS be used when the child is using the
booster seat with the child harness as it ensures the lap belt is correctly positioned on the
child's hips.
A loose or poorly positioned lap belt can move up into the abdomen and cause serious
injuries in a crash.
NOTE: Some vehicle seatbelts are too short and you may experience some difficulty
fitting the converted lap-sash around your child. If so, adjust the gated slide nearer to your
child, ideally under the armrest and lap belt recess area (ensure the slide does not touch
your child). This should provide more belt length to fit your child, but if the belt still will not
fit, try another location in the vehicle. If the vehicle belts are still too short, then contact the
vehicle manufacturer for advice on longer seatbelts.
30
Instructions for Installation & Use
Advertisement
Table of Contents
