Table of Contents
Advertisement
HOW TO INSTALL WITH A CHILD HARNESS
C. Repeat previous step A for the other slot in the Gated
Slide.
D. Feed the straps through the Gated Slide to remove any
slack. This has now converted the lap-sash seatbelt
so it will act like a lap only seatbelt.
Hollow side towards the child
TO ENSURE CORRECT CONVERSION OF LAP-SASH SEATBELT TO LAP SEATBELT FOLLOW
THESE STEPS.
IMPORTANT:
The Gated Slide must be removed from the seat belt if the booster seat and child
harness are no longer used in the car so that other users can use the seat belt as a
lap sash seat belt.
IMPORTANT NOTE: Some vehicle seatbelts are too short and you may experience some
difficulty fitting the converted lap-sash around your child. If so, adjust the Gated Slide
nearer to your child, ideally into the lap belt recess area, (ensure the Gated Slide does
not touch your child). This should provide more belt length to fit your child, but if the belt
still will not fit, try another location in the vehicle, e.g. side seat. If the vehicle belts are
still too short, then contact the vehicle manufacturer for advice on longer seatbelts.
Loop on top
Sash portion
Instructions for Installation & Use - Series No. 4900/A/2010
C
Lap portion
D
Hollow side
towards child.
27
Advertisement
Table of Contents
