Table of Contents
Advertisement
INSTALLATION OF CAR ANCHOR FITTING
IF THE CAR IS FITTED WITH CHILD RESTRAINT
ANCHORAGE POINT
Locate the anchorage point behind the rear seating
position. (consult the car owners handbook for the
location of the anchorage point). The anchorage point
should be directly behind and central to the restraint.
Remove thread plug from the parcel shelf/floor/roof,
etc. and install attachment bolt and fitting as shown
in Fig.1.
CAUTION: DO NOT OVERTIGHTEN ATTACHMENT
BOLT. OVERTIGHTENING MAY FRACTURE OR BREAK
BOLT. MAXIMUM TORQUE IS 20 Nm (14.75 ft.lb.)
Note: Minimum of five full turns of attachment bolt is
required before tightening force is applied.
IF THE CAR IS NOT FITTED WITH CHILD RESTRAINT
ANCHORAGE POINTS
For Sedans only - Drill 9mm diameter hole in the
parcel shelf on the centre line of the seating position
as shown in Fig.3. Before drilling the hole, check the
underside for accessibility. Install the attachment bolt
as shown in Fig.2.
For vehicles other than Sedans - In Australia, consult
your nearest child restraint fitting station or traffic
authority for vehicle inspection to find the best, correct
position for the placement of the anchorage point,
and for the correct attachment bolt length and use of
spacers. In New Zealand, consult the agent for the
vehicle.
Note to Queensland purchasers: The installation of
anchorage points must be approved by authorised
officers appointed by Queensland Transport.
Authorised officers can be sourced from all
Queensland Transport Customer Service and
Queensland Ambulance Service Centres.
UPPER ANCHORAGE
Fig.1.
Vehicle
trim
UPPER ANCHORAGE
FITTINGS FOR SEDANS
Fig.2.
Vehicle
trim
Instructions for Installation & Use - Series No. 4900/A/2010
FITTING
Attachment Bolt
Lock washer
Anchor
fitting
Spacer(s) if
required
Vehicle metal
structure
Front of Vehicle
ONLY
Attachment Bolt
Anchor fitting
Spacer(s) if
required
Vehicle metal
structure
Reinforcing
washer (cone
downwards)
Lock washer
Secure nut
39
Advertisement
Table of Contents
