Britax Encore 10 Instructions For Installation And Use Manual page 14

Child booster seat
Table of Contents

Advertisement

HOW TO SETUP
ADJUSTING THE SLIDEGUARD™CLIP
POSITION
The crotch strap length adjuster can be found under the seat
located by opening the instruction book flap.
A. Adjust the crotch straps for the SLIDEGUARD™clip to
the correct length for your child. It should be kept as low
as possible to keep the lap portion of the seatbelt engaged
low-over the hips. Ensure the SLIDEGUARD™clip does not
push into your child's thighs as this may cause discomfort.
ALWAYS USE THIS DEVICE.
B. To change the length of the
crotch strap, thread through the
adjuster in the direction of the
arrows shown below.
TO SHORTEN
IMPORTANT :
You must adjust the crotch strap to the correct length for your child before installing the
restraint as it cannot be adjusted in the car.
Always return the crotch strap to its original shorter length when using the seat with
a smaller child. The SLIDEGUARD™clip must always be positioned low down on your
child's body - it will not connect correctly with the seatbelt if it is too high. DO NOT
attempt to remove or dismantle the crotch strap.
14
Instructions for Installation & Use - Series No. 4900/A/2010
TO LENGTHEN
Adjuster
Under booster seat
Lower edge of
SLIDEGUARD™ Clip,
level with top of thighs.

Advertisement

Table of Contents
loading

Table of Contents