Figure 4.4 Rear Of Primepower400 Pedestal Server; Rear Side - Fujitsu Primepower200 User Manual

4.2.3 Rear side

The names and functions of parts on the rear of the PRIMEPOWER400 Pedestal Server are as follows.
(8) Keyboard port
(3) Power control port
(1) AC power inputs
(2) PCI slots
(3) Power control port (label : PC)
(4) UPS port (label : UPS)
(5) RCI port (label : RCI)
(6) Serial port A
(7) Serial port B
(4) UPS port
Figure 4.4
Connect the power cables to these points. Both AC power cords must be plugged into the same
power grid / circuit.
 PCI slots conform to the PCI local bus specifications (Rev. 2.1).
 64-bit bus, 33MHz (5.0 V) and 33/66MHz (3.3V) are supported.
 Both short cards (17.46 cm, 6.87 in.) and long cards (31.19 cm, 12.3 in.) are supported.
8-pin DIN for power control
Dsub-9 pin for connecting the signal cable of an uninterruptible power supply
RJ11 connector for connecting the RCI cable and terminator (provided with the server unit)
(5) RCI port (9) 100Base-TX port
Rear of PRIMEPOWER400 Pedestal Server
4.2 Names and Functions of Parts
(1) AC power inputs
(2) PCI slots
51