Preparations For Use - Fujitsu Primepower200 User Manual

CHAPTER 7 PRIMEPOWER600 Pedestal Server
(8), (9) Serial ports (label : SERIAL A/B)
(10) Keyboard port (label : KB)
(11) 100Base-TX port (label : LAN)

7.3 Preparations for Use

This section describes the following:
 Installation notes and specifications
 Connecting the console
 Turning power on and off
 Installing the Enhanced Support Facility package
 Enabling/disabling the break signal
 LAN expansion note
7.3.1 Installation notes
CAUTION
 Do not block the ventilation holes.
 Do not install the PRIMEPOWER600 Pedestal Server where it will be exposed to sunlight or sources of heat.
 Do not install the PRIMEPOWER600 Pedestal Server in dusty places or places where it will be exposed to
corrosive gases or sea breezes.
 Keep the PRIMEPOWER600 Pedestal Server isolated from vibration. Install the PRIMEPOWER600 Pedestal
Server on a level surface so that it does not tilt.
 Make sure that the AC power supply source is grounded properly using a maximum resistance of 100 Ohms.
Also, do not ground the AC power supply source using a shared ground. Use only an independent grounding
point. Otherwise, the PRIMEPOWER600 Pedestal Server may malfunction.
 Do not run a cable under a unit or allow a cable to become taut. Do not disconnect the power cable when the
power is on.
 Do not place anything on the PRIMEPOWER600 Pedestal Server. Do not use the top of the
PRIMEPOWER600 Pedestal Server as a workspace.
122
Dsub-25 pin ports for connecting a console terminal when performing maintenance on the server
unit using the RS-232C interface
8-pin DIN port for connecting a keyboard cable
RJ45 connector automatically recognizes at 10Mbps/100Mbps
Unit Damage
If the following notes are not observed the PRIMEPOWER600 Pedestal Server
may be damaged. Be sure to follow these notes.