Ejecting A Data Cartridge - Fujitsu Primepower200 User Manual

CHAPTER 11 Internal I/O Units
3
Lower the cartridge handle.
The Operate Handle LED goes out, and the Tape in Use LED starts to blink. When the Tape in Use LED
(amber) stops blinking and lights up, this indicates that the tape has been mounted.

11.6.8 Ejecting a data cartridge

The following describes how to eject data cartridges.
1
Press the Unload switch on the right of the front panel. The Tape in Use LED (amber) blinks, and the tape
starts to rewind.
2
When the Operate Handle LED (green) lights up and the buzzer sounds, lift up the cartridge handle.
222