Disk Drive Configurations - Fujitsu Primepower200 User Manual

CHAPTER 10 Expansion File Unit Type-2
10.3.2 Installation specifications
Table 10.2 shows the installation specifications of the Expansion File Unit Type-2.
*1:
*2:
10.4 Disk Drive Configurations
In the base configuration, up to five disk drives can be mounted. Adding a File Unit Expansion Kit enables up to
ten disk drives to be mounted. Alternately, adding a Tape Unit Bay Kit enables up to two 8mm tape units or DDS3
DAT drives to be mounted.
Removing the front cover allows you to access the disk drive cages as shown in Figure 10.3 and Figure 10.4 .
Figure 10.3 shows the disk drive configuration when a File Unit Expansion Kit is added to the Base SCSI Unit.
Figure 10.4 shows the disk drive configuration when a Tape Unit Bay Kit is added. The base disk cage (bays #1 to
#5) and the expansion disk cage (bays #1 to #5) or tape drive cage (bays #1 and #2) are connected to the
PRIMEPOWER Server by separate SCSI buses.
IMPORTANT
Set the SCSI ID of the tape unit in tape bay #1 to "5" and the SCSI ID of the tape unit in tape bay #2 to
"3".
182
Table 10.2 Installation Specification of Expansion File Unit Type-2
Item
Weight
Power Supply Frequency
Voltage
Max. Current
Leak Current
Frame Resistance
Temperature Operating
Non-operating
Humidity Operating
Non-operating
Vibration Operating
Non-operating
Noise
Form Factor
If the ambient temperature exceeds 35 deg. C (95 deg. F) during operation, a warning message is
displayed. Take steps to rectify the problem immediately.
The indicated noise is the mean value of the measurements obtained in an anechoic chamber with
less echoic influence. The actual noise measured at the installation site may be greater than the
indicated noise due to background noise and echoes.
Specification
30 kg (66.14 lb.) (max.)
50/60 Hz (+2 ~ -4%)
Single phase Single phase
±
AC100 ~ 120V ( 10%) AC200
1.5 A (240V)
3.0 A (100V)
²
3.5 mA
²
100Ω
û
5 ~ 35 C (+41 ~ +95 F) (*1)
û
0 ~ 50 C (+32 ~ +122 F)
20 ~ 80% RH (non-condensing)
8 ~ 80% RH (non-condensing)
0.2 G
0.4 G
50 db(A) (*2)
Rackmount (4U)
±
~240V ( 10%)