Preparations For Use - Fujitsu Primepower200 User Manual

CHAPTER 2 PRIMEPOWER200 Pedestal Server

2.3 Preparations for Use

This section describes the following:
 Installation notes and specifications
 Connecting the console
 Turning power on and off
 Installing the Enhanced Support Facility package
 Enabling/disabling the break signal
 LAN expansion note
2.3.1 Installation notes
CAUTION
 Do not block the ventilation holes.
 Do not install the PRIMEPOWER200 Pedestal Server where it will be exposed to sunlight or sources of heat.
 Do not install the PRIMEPOWER200 Pedestal Server in dusty places or places where it will be exposed to
corrosive gases or sea breezes.
 Keep the PRIMEPOWER200 Pedestal Server isolated from vibration. Install the PRIMEPOWER200 Pedestal
Server on a level surface so that it does not tilt.
 Make sure that the AC power supply source is grounded properly using a maximum resistance of 100 Ohms.
Also, do not ground the AC power supply source using a shared ground. Use only an independent grounding
point. Otherwise, the PRIMEPOWER200 Pedestal Server may malfunction.
 Do not run a cable under a unit or allow a cable to become taut. Do not disconnect the power cable when the
power is on.
 Do not place anything on the PRIMEPOWER200 Pedestal Server. Do not use the top of the
PRIMEPOWER200 Pedestal Server as a workspace.
 To prevent condensation in the PRIMEPOWER200 Pedestal Server, do not raise the ambient room
temperature rapidly in winter.
Use the PRIMEPOWER200 Pedestal Server only after it has warmed up sufficiently.
 Do not install the PRIMEPOWER200 Pedestal Server near EM noise generating devices such as
photocopiers, air conditioners, or welders.
 Take electrostatic prevention measures. Note that some carpets generate static electricity easily and can cause
the PRIMEPOWER200 Pedestal Server to malfunction.
 When moving the PRIMEPOWER200 Pedestal Server, do not pull on the front cover. Otherwise, the Server
may be damaged.
10
Unit Damage
If the following notes are not observed the PRIMEPOWER200 Pedestal Server
may be damaged. Be sure to follow these notes.