Control Panel - Fujitsu Primepower200 User Manual

CHAPTER 7 PRIMEPOWER600 Pedestal Server
7.2.2

Control panel

The PRIMEPOWER600 Pedestal Server is provided with the control panel shown in Figure 7.3 .
Note:
(1) RESET switch (push button)
(2) MODE switch (3-position slider)
118
(1) RESET Switch
(3) REQUEST Switch
(2) MODE Switch
To prevent erroneous operation, all push-button switches on the control panel are designed not to
function unless held down for at least 0.3 seconds.
CAUTION
The RESET switch is used to reset the system to its initial state and is enabled or disabled by the
MODE switch described in "(2) MODE switch".
CAUTION
The MODE switch has three settings and is used to specify the run mode at power on or system
reboot, and to whether the POWER, RESET and REQUEST switches are "enabled" or "disabled".
REQUEST RESET CHECK POWER
SECURE
MANUAL
AUTO
(6) CHECK LED (Amber )
Figure 7.3 Control Panel
Data Destruction
Pressing the RESET switch while the system is running may cause
data to be lost.
Data Destruction
Install the "Enhanced Support Facility" before using the system.
Without this package, a front panel-miss operation or hardware
error may cause the system to shutdown or data to be lost.
(4) LCD Panel
(5) POWER Switch
(7) POWER LED (Green)