Lan Expansion Note - Fujitsu Primepower200 User Manual

How to enable the break signal and STOP+A command

5.3.8 LAN expansion note

When LAN ports have seen added with PCI cards, and each LAN port given its own MAC address, these should
be enabled from the ok prompt, as follows:
2
Use the set-fw-options command to set the value (no-break) for disabling the break signal and
STOP command.
ok set-fw-options no-break
fw-options = no-break
3
Use the print-fw-options command to make sure that no-break is correctly set.
ok print-fw-options
fw-options = no-break
1
Use the print-fw-options command to check the current setting values. If the no-break shown
below is not displayed, the break signal and STOP+A command are already enabled.
ok print-fw-options
fw-options = no-break
2
Use the clear-fw-options command to cancel the no-break setting.
ok clear-fw-options no-break
fw-options =
3
Use the print-fw-options command to make sure that nothing is set.
ok print-fw-options
fw-options =
ok setenv local-mac-address? true
5.3 Preparations for Use
81