To Set The Clock - Daikin Super Multi NX C-Series Service Manual

Instruction

" To set the clock

1. Press "CLOCK button".
2. Press "TIMER setting button" to set the
3. Press "CLOCK button".
" Turn the breaker ON
•
NOTE
" Tips for saving energy
" Please note
126
0:00 is displayed.
blinks.
clock to the present time.
Holding down " " or "
increases or decreases the time display.
: blinks.
Turning ON the breaker opens the flap, then
closes it again. (This is a normal procedure.)
• Be careful not to cool (heat) the room too much.
Keeping the temperature setting at a moderate level helps
save energy.
• Cover windows with a blind or a curtain.
Blocking sunlight and air from outdoors increases the cooling
(heating) effect.
• Clogged air filters cause inefficient operation and waste
energy. Clean them once in about every two weeks.
• The air conditioner always consumes 15-35 watts of electricity even while it is not operating.
• If you are not going to use the air conditioner for a long period, for example in spring or
autumn, turn the breaker OFF.
• Use the air conditioner in the following conditions.
Mode Operating conditions
COOL Outdoor temperature:<3/4MK> 10 to 46 °C
Indoor temperature: 18 to 32 °C
Indoor humidity: 80% max.
HEAT Outdoor temperature:<3/4MX> –15 to 21 °C
Indoor temperature: 10 to 30 °C
DRY Outdoor temperature:<3/4MK> 10 to 46 °C
Indoor temperature: 18 to 32 °C
Indoor humidity: 80% max.
• Operation outside this humidity or temperature range may cause a safety device to disable the
system.
" button rapidly
If operation is continued out of this range
• A safety device may work to stop the operation.
<3/4MX> –10 to 46 °C (In multi system, it may work to stop the operation of the outdoor unit only.)
• Condensation may occur on the indoor unit and drip.
• A safety device may work to stop the operation.
• A safety device may work to stop the operation.
<3/4MX> –10 to 46 °C • Condensation may occur on the indoor unit and drip.
SiE12-411
C
HOME LEAVE
ON/OFF
TEMP
POWERFUL
MODE FAN SWING
SILENT SENSOR
ON CANCEL
OFF
TIMER
Recommended temperature setting
For cooling: 26°C – 28°C
For heating: 20°C – 24°C
System Configuration
2
1.3