GE D20MX Instruction Manual page 49

CHAPTER 3: CONNECTING TO DEVICES AND NETWORKS
D20MX INSTRUCTION MANUAL
Figure 18: SGConfig - Host name shown in the LAN Settings
Table 18: Host name suffix conventions
HostName Suffix
AA
AB
BA
BB
The D20MX can be in one of five modes as defined in Table 19. You can find the current
mode of the D20MX by navigating to the SHELL in WESMAINT II+ and typing the
command el.
Table 19: System mode definitions
Mode Description
Active D20MX applications are operational.
Standby D20MX applications are not operational but are
ready to take over on a switchover command or
a failover.
Disabled D20MX applications have been suspended due
to an error. You must type el /r and boot in the
SHELL to clear this error.
Debug D20MX boot sequence has been interrupted by
pressing CTRL-E. Put the CCU into this mode in
order to recover a system that has a corrupted
configuration or code image.
Service Mode D20MX configuration has been corrupted or is in
the process of receiving a new configuration. To
recover the system, you must download a
configuration serially.
IP Address Corresponds To...
CCU A, LAN A
CCU A, LAN B
CCU B, LAN A
CCU B, LAN B
GE INFORMATION
Example
FAC_DEFAA
FAC_DEFAB
FAC_DEFBA
FAC_DEFBB
Partial "el" output
Active CCU YES
Standby CCU YES
Disabled YES
Redundant CCU NO
Standby CCU NO
Active CCU NO
Service Mode NO
Sys Service Mode NO
Disabled NO
Service Mode YES
49