GE D20MX Instruction Manual page 78

78
Result: The two files D20MX01-14X.zip and D20MX02-14X.zip appear in the
dialog.
3.4. Select the appropriate file based on your decision in step 2.
3.5. Click OK.
Result: On completion a pop-up message appears (e.g., Project D20MX01-14X
has been restored).
3.6. Click OK.
4. Open the SGConfig project containing the D20 or D200 device.:
4.1. Click the GE button.
4.2. Click the required SGConfig project in the Recent Projects list or select the
Open Project menu item.
5. Make a backup copy of the original D20 or D200 device configuration:
5.1. Click the Project tab of the original D20 or D200 device configuration.
5.2. Click the D20 or D200 device.
5.3. Click the ribbon Configure group > Edit > Copy.
5.4. Click a blank area on the page onto which the copy is to be placed.
5.5. Click the ribbon Configure group > Edit > Paste.
Result: The Copying device window appears.
Result: Once completed a new device named COPY_OF_<original device
name> or <original device name>_COPY appears.
6. Change the device type to D20MX.
6.1. Click the Project tab of the original D20 or D200 device configuration.
6.2. Click the D20 or D200 device.
6.3. Click the ribbon Configure group > Configuration > Hardware > Processor >
Change Type.
Result: The Change Device dialog appears.
6.4. Select the D20MX type and click OK.
Result: A dialog is displayed indicating that the device type has been changed
successfully.
6.5. Click OK.
Result: The device is now displayed as a D20MX.
7. Select a D20MX processor from the D20MX Device Wizard:
7.1. Click the Project tab of the original D20 or D200 device configuration.
7.2. Click the D20MX device.
7.3. Click the ribbon Configure group > Edit > Properties.
7.4. Click Next until the Processor tab appears.
7.5. Click the Processor tab > General sub-tab.
7.6. From the Part Number field, click Select.
Result: The Select a Processor Card window appears.
7.7. Select one of the three D20MX processor type part numbers (526-3001, 526-
3003 or 526-3005).
7.8. Click OK, Next, and Finish.
Result: The D20MX Device Wizard closes.
8. Import the firmware definition from the factory default configuration (if you had opted
to upgrade the firmware in ConfigPro, then this step is not necessary):
8.1. Click the Project tab of the original D20 or D200 device configuration.
8.2. Click anywhere on the main page of the project to deselect the device.
CHAPTER 5: CONFIGURING THE SOFTWARE
GE INFORMATION D20MX INSTRUCTION MANUAL