GE D20MX Instruction Manual page 86

Updating a D200 configuration to use the D20MX firmware
definition with ConfigPro
Prerequisites
Procedure
86
34. Click No because you have already made a backup.
Result: Messages appear indicating the upgrade is in progress. Messages appear in
the Device Log indicating the results of the upgrade. The D20 device appears with a
red dot.
35. Review all warnings and make corrections as needed, reviewing the original copy to
retrieve values that may have been replaced with default values during the upgrade
36. Right-click on the device and click Generate.
Result: The device appears without a red dot.
37. Right-click on the device and click Archive > Save.
Result: The Save Device to ZIP File dialog appears.
38. In the "Save To" area, click the folder icon.
Result: A dialog appears with the title "Select a directory in which to save the project".
39. Navigate to a folder on your PC where you would like to save the device archive and
click Select and OK.
40. Close ConfigPro.
41. Migrate the D20 Device Archive into SGConfig using the Migration Wizard (Refer to the
Migration Wizard screencast).
Before you can update the firmware definition of a D200 device configuration, the
following components must be present
• ConfigPro 5.03 or higher installed on the configuration computer.
• D20MX Documentation CD (part no. 588-0075 V14X) in either of the following formats:
– Physical CD media, or
– Zip file
Migrating a multi-processor D200 only transfers the application configurations on the first
processor.
This is manually resolved by moving applications from other processors to the first
processor using the ConfigPro device editing functions BEFORE converting the device to a
D20 in the instructions below.
Single and multi-processor D200 devices must first be changed into D20 devices before
the D20MX firmware definition can be selected.
To change a D200 device into a D20 device perform the following steps:
1. Start ConfigPro 5.03 or higher.
Result: The main window of ConfigPro appears with the tree view of the project
directory on the left.
2. Make a backup copy of the project you want to transfer to the D20MX.
2.1. Select from the menu, Project > Copy Project.
Result: The Copy Project dialog appears.
2.2. In the "From" area, navigate to the folder and select the project you want to
transfer to the D20MX.
2.3. In the "To" area, enter a new unique name for the project.
CHAPTER 5: CONFIGURING THE SOFTWARE
GE INFORMATION D20MX INSTRUCTION MANUAL