Table of Contents
Advertisement
38
Figure 11: Cable to fiber optic daughter card
P1 connector on Fiber
optic daughter card
8.
If the D20MX is being installed in a VME chassis, connect the 0 V cable (part number
975-1237):
8.1.
Connect the bare end of the 0 V cable wire to the O V connector on the
WESTERM terminal block TB2-9.
8.2.
Remove the wire from the lower 0 V connector on the VME backplane and
connect this wire to the male end of the 0 V cable.
8.3.
Connect the female end of the 0 V cable to the lower 0 V connector on the VME
backplane.
See Figure 12, "0 V cable connection".
Figure 12: 0 V cable connection
WESTERM D20M+ SS
Termination Panel
Cable
0 V
Cable
GE INFORMATION
CHAPTER 2: INSTALLING THE D20MX
J3 and J4 connectors
on D20MX PCB
D20 Chassis - view
through top panel
WESTERM D20VME -
VME Bus Backplane
D20 VME Chassis
D20MX INSTRUCTION MANUAL
Advertisement
Table of Contents
