FRU information (service only)
The field replaceable unit (FRU) procedures are intended for trained servicers who
are familiar with IBM products.
IntelliStation Z Pro Type 6221
The following section contains information about removing components of the
IntelliStation Z Pro Type 6221.
Front adapter-retention bracket assembly
Note: Read "Installation guidelines" on page 35 and the safety notices at "Safety
Complete the following steps to remove the front adapter-retention bracket
assembly:
1. Turn off the computer and attached devices; then, disconnect all power cords
2. Remove the cover and support bracket (see"Removing the side cover" on page
3. Pivot the card guide to the raised position; then, remove all adapters (see
4. Slide the bar out of the circular slots and pull the card guide out of the chassis.
© Copyright IBM Corp. 2002
information" on page 117.
and external cables.
39 and "Removing and installing the support bracket" on page 42).
Note: It may be easier to complete this procedure if the computer is laying on
its side.
"Installing an adapter" on page 45).
Note: In the following illustration, the drive cage is not shown.
69