Memory Clear; Memory All Clear (Ram Clear) - Sam4s ER-230 Series Operation And Program Manual

Memory Clear

Memory All Clear (RAM Clear)

CAUTION: The procedures described in this area are security sensitive. Clearing all or parts of
the ER-230 Series memory may cause damage or loss to the program. Do not share this
information with unauthorized users.
Perform "Clear All Totals", or "Clear PLU File" if you wish to clear only parts of ER-230 Series
memory. Complete clearing of all memory areas and installation of the default program can be done
through the following special procedure:
To Perform a Memory All Clear (reset memory completely):
1. Turn the power switch located on the right side of the register to the OFF position.
2. Press and hold the key position where the CHECK key is located on the default keyboard
layout.
3. Continue to hold the CHECK key while turning the power switch to the ON position.
4. After hear BEEP, release CHECK key, "ALL CLEAr" will appear on the display.
5. Press the upper left key (RECEIPT FEED) of the keyboard, then the lower left key
(CANCEL), then the upper right key (MODE), and finally press the lower right key
(CASH). "g"-"O"-"O"-"d" will appear on the display as you press each key one by one.
RECEIP
T FEED
VOID
ERROR
CORR
RETURN
CANCEL
6. Display will show "= = = = = = = = = = = =" while proceeding.
7. When memory is cleared, the register prints a message "RAM ALL CLEAR OK!"
Sam4S ER230 Series Electronic Cash Register AU
- CLEAR PLU
X/TIME
+%
7 8
-% 4 5
MACRO1
1 2
SCALE
0
00
#/NS RA PO
9 1 5 9
6
2 6 10
3 7 11
3
. 4 8 12
CLERK
MODE
CHG1 CHG 2
CONV1
CHECK
SBTL
CASH
Getting Started • 13