Rear Swing Arm - TGB BLADE 250 Service Manual

Install driven sprocket, drive chain, drive chain
cover and brake caliper.
Caution
● Note the chain lock clip direction.
Install rear wheel shaft connecter, rear wheel.
Driven sprocket inspection
Check the condition of the driven sprocket teeth.
Replace the sprocket if it worn.
Caution
● The drive chain, drive sprocket and driven
sprocket must be also inspected for wear.

Rear swing arm

Removal
Remove rear under protect, drive chain, driven
sprocket, rear brake caliper, brake disk and rear
axle.
Remove 2 nuts and bolt, and remove rear axle
holder.
Remove rear swing arm lock nut.
Remove rear swing arm bolt, and then remove
rear swing arm.
To this chapter contents
16. REAR BRAKE & REAR WHEEL & REAR CUSHION
Moving direction
o
Lock nut
Master link
Lock clip
X
16-9