TGB BLADE 250 Service Manual page 10

● Lubricate the rotation face with specified
lubricant on the lubrication points before
assembling.
● Check if positions and operation for installed
parts is in correct and properly.
● Make sure service safety each other when
conducting by two persons.
● Note that do not let parts fall down.
● Before battery removal operation, it has to
remove the battery negative (-) cable firstly. Notre
tools like open-end wrench do not contact with
body to prevent from circuit short and create
spark.
To this chapter contents
● After service completed, make sure all
connection points is secured.
Battery positive (+) cable should be connected
firstly.
● And the two posts of battery have to be greased
after connected the cables.
● Make sure that the battery post caps are
located in properly after the battery posts had
been serviced.
● If fuse burned, it has to find out the cause and
solved it.
capacity fuse.
1. GENERAL INFORMATION
And then replace with specified
Capacity
verification
1-5