Patrol; Figure 19: Gvr3550 Ptz C - Grandstream Networks GVR3550 User Manual

PATROL

When set PTZ to patrol, users could edit and use patrol path on the control panel. The factory default
setting is 4 empty patrol paths. See Figure 19.
1. Set PTZ to patrol.
2. Select the patrol path.
3. Set the residence time the patrol path stays at each preset.
4. Click on to add key point and set it as one preset. Users could click on
corner of the panel to delete the preset.
5. Click on before the patrol path, when it turns to a triangle
path. Click again to stop the patrol.
Grandstream Networks, Inc.
Figure 19: GVR3550 PTZ Control Page – Patrol
GVR3550 User Manual
Firmware Version 1.0.0.65
in the lower right
, the PTZ will cycle according to the
Page 39 of 120
Last Updated: 10/2014